:: CTBA - Enlight ::

Enlight

Enlight Bonding System Highly filled light-cure adhesive. Bis-GMA resin for superb handling characteristics, easy cleaning. Highly active initiator system supports reduced cure times.

Request Product

Detail & Product.

ENLIGHT
• Highly filled light-cure adhesive
• Superb handling characteristics
• Highly active initiator system
• Unidose™ and syringe delivery options

ENLIGHT LV (LOW VISCOSITY)
• Flowable low-viscosity paste designed for lingual
retainers and indirect bonding
• Highly active initiator system
• Unidose delivery for easy placement

Tooth preparation

Place the lip/cheek retractor and saliva ejector in the mouth. clean the teeth thoroughly with pumice and water. Rinse with water while using a high speed evacuation system. Dry the teeth with air syringe.
Apply the etchant solution to the bonding surfaces with applicator sponges. Gently dab the etching solution : do no rub. A continuous dabbing of fresh solution for 30 seconds is most effective. Rinse thoroughly with a forceful air-water spray and suction using high speed evacuator. Maintain a dry field. Do no allow the patient to rinse or permit contact of the etched enamel with saliva or mucosal tissue.
Dry the etched enamel with clean, dry air, The etched enamel must now have a uniform, dull frostily appearance.

Bonding Procedure

Dispense a small amount of sealant on the mixing pad. apply ortho solo sealant to teeth using the brushes provided. A thin, uniform coating should extent from the gingival crest and cover all of the etched enamel. Replace the cap immediately after dispensing sealant.
Extrude a small amount of enlight adhesive paste into the base of the bracket pad. After application, clean the tip and replace cap.
Place the bracket onto the tooth surface immediately after applying adhesive.
Adjust the bracket to its final position and press firmly.
Remove the excess adhesive from the periphery of the brackets base.
Expose the adhesive for 10 second for metal brackets, and 5 second for ceramic brackets. shining the light directly through the bracket bonds ceramic brackets. Divide the curing time and shine the light on the mesial and distal edges of the brackets to bond metal brackets.
Active archwires may be placed immediately after curing the last bracket.